MEP - VOLLAUTOMAT SHARK 332-1 NC 50

•  
  Reference number 1108-66310

  Operation Hours not applicable

• Vendor

  WMT GmbH & Co.KG
  Siemensstraße 1
  46342 Velen-Ramsdorf

  Germany

  

• Main Category

  Metal working machines

• Category

  Sawing, Filing and Cutting-off Machines

• Type of Machine

  Band Sawing Machines (Vertical)

• Manufacturer

  MEP - VOLLAUTOMAT

• Control

  NC

• Technical data

  cutting diameter

  300 mm

  saw band length

  3320 x 27 x 0,9 mm mm

  cutting width

  300 mm

  Control

  NC

  capacity 90 degrees: flat

  330x 260 mm

  capacity 90 degrees: square

  260 x 260 mm

  capacity 45 degrees: square

  250 mm

  capacity 45 degrees: flat

  270 x 200 mm

  capacity 60 degrees: round

  180 mm

  capacity 60 degrees: square

  170 mm

  band speed

  15 - 100 m/min

  total power requirement

  2,2 kW

  weight of the machine ca.

  1,1 t

  dimensions of the machine ca.

  3,3 x 2,83 x 2,23 m

• Description

  Furnishing:
  - fully automatic electro-hydraulic band saw with additional
  semi-automatic, semi-automatic-dynamic and
  manual operation
  - Automatic cycle (cuts from 0° to 60° left)
  - Semi-automatic, semi-automatic-dynamic and
  manual cycle (cuts from 45° right to 60° left)
  - Manual or semi-automatic dynamic cycle to make cuts outside
  of series production can be carried out directly without programming.
  - Numerically controlled band saw machines with the new, especially from MEP
  Windows CE based controller developed for automatic machines.
  - User interface with touch screen display of 7 and mechanical buttons for
  the operating functions of the sawing machine.
  - Stepless regulation of the cutting speed from 15 to 100 m/min
  Frequency converter (inverter).
  - Material feed with stepper motor via ball screw
  - which is mounted on opposite ball bearings; Single stroke 600 mm
  - repeatable to cut to any length.
  - Automatic monitoring of cutting load
  - through a servo valve mounted directly on the cylinder.
  - The coolant pan is installed in the base frame
  - Chip clearing brush.
  - Bimetal saw band for solid and profile material.
  - Tools and instructions for use with a list of spare parts
  
  
  This ad was created with MODUL MWS - the software solution of LogoTech.

• State

  Used